The walls
Earth, poured and rammed
The walls are made from subsoil — the dense, gritty layer below the topsoil, which is no use to a garden and ideal for a wall. It is mixed with a little sand and a small proportion of cement or lime, then put into formwork and left to harden into one continuous mass. No blocks, no mortar joints, no firing.
Two methods, and we use both. Rammed earth goes in barely damp — squeeze a handful and it holds its shape — in layers of a few inches at a time, each compacted hard before the next is added. Those layers stay visible in the finished wall as fine horizontal strata, which is the whole reason people fall for the material. Poured earth is a wetter, flowing mix that fills the formwork on its own, giving a smoother and more monolithic face. It suits the places that are awkward to ram.
The walls end up thick — far thicker than a brick wall doing the same job. That thickness is not structural excess; it is the climate control. Earth has enormous thermal mass and very little insulation value, which means it does not block heat so much as delay it. Sun falling on the wall in the afternoon takes most of a day to work its way through, by which time the evening has arrived and the heat comes out into a cool night instead of a hot room. In a place with a wide gap between day and night temperatures, that lag does the work an air conditioner would otherwise do.
What actually decides whether an earth wall lasts a century is embarrassingly simple, and every earth builder repeats it: a good hat and a good pair of boots. A roof that overhangs far enough to keep rain off the face, and a stone plinth that lifts the earth clear of splashback and rising damp. Get those two right and the wall is fine. Get them wrong and no amount of cement in the mix will save it.